Maximum Build Volume

ScottR_UK Level 1 - Starter Points: 0
Posts: 1

Location: United Kingdom
Posted by

Posted Oct 10, 2017 - 4:56 AM  

I have been the page and followed the instructions. But I cannot get a 195 x 195 square to slice on an Ultimaker 3 Extended using Cura 2.7.

I downloaded the profile and use that - it does not work

I follow the detail to set manually - it does not work

What am I missing?

The spec sheet states Dual material: 197 x 215 x 200 mm as the maximum build volume.

SandervG Team Ultimaker Points: 8653
Posts: 4795
Location: Geldermalsen, Netherlands Printers: Ultimaker Original+, Ultimaker 2+
Posted by

Posted Oct 10, 2017 - 8:10 AM

Could you share with us a screenshot of your buildvolume to see what you have done and which areas are preventing you from printing?

I am guessing you have the prime blob still enabled (under build plate adhesion).

If you deselect it you should be able to print a 195x195x195 cube. Good luck!

1 reply