Display and controller
When turning on your Ultimaker 2, you will always see the Ultimaker logo first after which you will go to the main menu. The main menu offers three options: Print, Material and Maintenance.

The “Print” menu simply allows you to select one of the print files on the SD card and will automatically start the print after that.
Material
In the “Material” menu you can either change the filament on your Ultimaker 2 or change the settings of material profiles. When selecting “Change” the Ultimaker 2 will start the procedure as described in the Bed leveling section. In the “Settings” menu you can select material profiles and change their settings in the “Customize” menu.
Maintenance
The “Maintenance” menu offers various options. By selecting “Build plate” you will be guided through the bed leveling steps. In the “Advanced” menu several options can be selected in order to manually do certain actions or change machine settings.
Fine-tuning
The Ultimaker 2 also offers you the possibility to fine-tune settings during the printing process. This allows you to get full control over the printing process and helps you achieving the best print results. You can do this by accessing the “Tune” menu during printing. The Tune menu basically shows you the same settings as in the Advanced menu, which means that you can change settings like for example the temperature and speed of printing. Furthermore, it is possible to select “Pause”, after which you can change the filament in the middle of a print and resume again.
-
Ultimaker 3
- Get started
- Operation
-
Maintenance
- Updating the firmware
- Storage and handling of materials
- Maintenance schedule
- Clean the printer
- Lubricate the axles
- Check for play on axles
- Check the tension of the short belts
- Check for residue in the front fan of the print head
- Check the quality of the silicone nozzle cover
- Lubricate the lead screw of the Z motor
- Clean the print cores
- Clean the feeders
- Replace the Bowden tubes
- Troubleshooting
- Downloads
- FAQ
- More support
-
Ultimaker 2+
- Get started
- Operation
-
Maintenance
- Updating the firmware
- Build plate calibration
- Storage and handling of materials
- Hardware maintenance
- Clean the printer
- Lubricate the axles
- Check for play on axles
- Check tension of short belts
- Lubricate the lead screw of the Z motor
- Retighten the hot-end isolator
- Clean the feeder and replace the Bowden tube
- Troubleshooting
- Downloads
- More support
-
Ultimaker Original+
-
Assembly
- Assembly
- What's in the box?
- Preparing the panels
- Assembling the frame
- Attaching various parts
- Sliding blocks
- Attaching the caps
- X and Y axles
- Z stage assembly
- Z stage installation
- Print head assembly
- Print head installation
- Aligning the print head
- Feeder assembly
- Bowden tube
- Spool holder
- UltiController
- Mounting the main board
- Connecting
- Electronics cover
- First use
- Printing
- Maintenance
- Troubleshooting
- Additional information
-
Assembly