Unboxing

The Ultimaker 2+ comes in reusable, durable packaging that has been specially designed to protect your Ultimaker 2+ in transport. To properly unpack your Ultimaker 2+, please follow the steps described below.

Start unpacking

Open cardboard box, grab the belt and carefully pull the Ultimaker 2+ out of the box. After this you can loosen the belt that's placed around the foam packaging.

Accessory box

Take out the Accessory box and open it to find the Quick Start Guide and several accessories.

Remove the foam packaging

Take the spool with PLA filament and a test print done on your Ultimaker 2+ out of the foam. Next, remove the foam packaging, take out the Ultimaker 2+ and place it on a flat surface.

Note: Hold the Ultimaker 2+ by the frame and do not hold it by the belts or axes while carrying it.

Remove the protection

Lift the build plate and remove the packaging material under the plate. At last, cut the zip tie that secures the print head and your Ultimaker 2+ is ready to use!

What's included?

The Ultimaker 2+ is supplied with an SD card in the 3D printer and several other accessories. Check if all these accessories are included before continuing.

Img4734_1

  1. 0.75 kg filament
  2. Power supply and cable
  3. Spool holder
  4. USB cable
  5. Nozzle kit
  6. Glue stick
  7. Grease
  8. Calibration card
  9. Hex wrenches (1.5 mm, 2 mm, 2.5 mm)
  10. Test print
  11. Glass plate

Index
Support