Spool holder

Parts needed

Parts needed
Parts needed

Assembling and installing the spool holder

The laser pack contains two different spool holders. The small spool holder can hold exactly one spool of Ultimaker filament. The larger spool holder can hold exactly two spools of Ultimaker filament.

  1. Take the two short wooden parts 11B and place two wooden parts 11C in the corresponding slots.
  2. Firmly push the wooden parts 11C down until it clicks into place.
  3. Repeat the steps above for the long spool holder, using four wooden parts 11C.
  4. Take one of the spool holders and slide it into the slots of wooden part 11A on the back panel.

Spool holder
Assembling the spool holder
Spool holder
The long and short spool holder

Spool holder
Place the spool holder onto the frame

Index
Support