UltiController

Parts needed

UltiController assembly

To assemble the UltiController, perform the following actions:

1. Remove the foil from the display and the window.
2. Place the wooden part front face down and fit the UltiController window in the cutout.
3. Insert four nylon M3x25 bolts through the wooden part front, put four 16 mm spacers over them and place the UltiPanel on top.
4. Secure the UltiPanel to the wooden part front with four nylon hex nuts by using the crosshead screwdriver.

   

   

   

   

   

   

5. Plug the flat cables into the connectors and mark the other end of the cable connected to EXP1.
6. Put the flat cables through the wooden part back and attach the back to the front with two nylon bolts M3x12 and two nylon hex nuts.
7. Attach the side part with two nylon bolts M3x12 and two nylon hex nuts each. Make sure to place the side with the SD card slot over the SD card holder.
8. Push the button in place.
9. Place the UltiController on the front panel and put the flat cables through the hole in the bottom panel.