Electronics cover

Parts needed

Placing the electronics cover

Now that all the cables have been connected, you will place a cover over the electronics to protect the main board.

1. Take the four M3x20 bolts and put a spacer 8 mm over each bolt.
2. Screw the four bolts into the main board’s threaded spacers, but only two turns.
3. Place the wooden electronics cover over the four bolts with the text facing towards you.
4. Slide the cover sideways until the bolts fit into the narrow part of the holes.
5. Tighten the four bolts to secure the electronics cover in place.

Congratulations! You have completed the assembly of the Ultimaker Original+.

Before you can start printing you must configure and calibrate your Ultimaker Original+. Therefore, make sure you follow the steps on the next pages carefully.