Using the Ultimaker 3 cleaning filament is the most effective way to unclog and keep print cores in optimal condition.
When to use the Ultimaker 3 cleaning filament
The Ultimaker 3 cleaning filament is used for both print core maintenance and unclogging procedures. We recommend performing regular maintenance once every three months. Unclog the print core if there is no material extruding from the nozzle for at least ten minutes.
How to use the Ultimaker 3 cleaning filament
This filament can be used to clean the Ultimaker 3 print core by applying hot and cold pulls. Hot pulls are used to get the biggest parts of carbonized material out of the print core and are highly recommended when the print core is clogged. With a cold pull, the remaining small particles will be removed, ensuring the print core is completely clean.
For detailed instructions on how to clean a print core with the Ultimaker 3 cleaning filament, take a look at this page.
Ultimaker 2+ Maintenance Kit
- Installing the Extrusion Upgrade kit
- Removing the cable cover
- Loosening the electronics
- Disconnecting the cables
- Replacing the feeder
- Replacing the build plate clamps
- Removing the print head
- Installing the new print head
- The bowden tube
- Guiding the cables
- Connecting the cables
- Attaching the main board
- Attaching the cable cover
- Aligning the axles
- Firmware and bed leveling
- Completing the upgrade
- Extrusion upgrade
- Advanced 3D Printing Kit for Ultimaker 2+
- Advanced 3D Printing Kit for Ultimaker 3
- Olsson block upgrade
Dual Extrusion kit
- Print head