Ultimaker 2+ Maintenance Kit

The Ultimaker 2+ Maintenance Kit contains the most commonly used replacement parts for the Ultimaker 2+ or Ultimaker 2 Extended+. It can be purchased in addition to your Ultimaker and used as an overall maintenance kit, or it can be used for spare parts.

What’s included?

Below you can find an overview of all the parts that are included in the maintenance kit.

Ultimaker 2+ Maintenance Kit

  1. 1x Glass plate
  2. 1x Bowden tube
  3. 1x PT100 B sensor
  4. 1x Heater cartridge
  5. 1x Magnalube
  6. 1x Machine oil
  7. 1x Calibration card
  8. 2x Build plate clamp
  9. 2x Clamp clip
  10. 2x Tube coupling collet
  11. 1x Hot end isolator
  12. 4x Olsson nozzles (0.40, 0.25, 0.60 and 0.80 mm)
  13. 2x TFM isolator coupler
  14. 1x Print head alignment aid
  15. 1x Hot-end cooling fan
  16. 2x Print cooling fan

To find out how to use or replace a specific part, search in the menu on the right, or click on the name of a part to be guided to a page with instructions.

Please note that there are no separate pages for the print head alignment aid or calibration card. The print head alignment aid is used in all repairs involving the hot end and ensures the correct spacing between the top and bottom parts. The calibration card is used for build plate leveling as described in the Ultimaker 2+ manual.

Maintenance schedule

To keep your Ultimaker 2+ in optimal condition we recommend the following maintenance schedule, based on 1,500 printing hours per year.

Every month  Every 3 months  Every year  
Clean printer  Check for play on axles  Clean feeder and replace bowden tube
Lubricate axles  Check tension of short belts 
 Lubricate lead screw Z motor 
 Re-tighten hot end isolator 

Note: If the usage frequency is higher, please increase the frequency of maintenance on your machine to maintain optimal printing results.

Index
Support