Unboxing

Remove the packaging

The Ultimaker S5 comes in reusable, durable packaging, specially designed to protect your 3D printer.

Follow the steps below properly to unpack your Ultimaker S5.

✔ Tip: We recommend removing the packaging with the box placed on the floor for safety. Please retain all packaging for warranty purposes.

  1. Remove the plastic locking clips from the lower section of the box.
  2. Holding the handles, lift the upper section of the box to reveal the printer.
  3. Lift the top foam section away from the printer, pulling the print head cable free.
  4. Remove the cardboard insert with the materials from the top of the printer.
  5. Place the printer on a flat surface.
  6. Slide the center seal at the bottom of the glass doors to one side, and then remove all of the remaining seals.
  7. Carefully open the glass doors and take out the accessory box and foam pieces from inside the printer.
  8. Remove the plastic protection from the touchscreen.

⚠Caution: When placing the printer on a shelf or table, take proper measures to prevent the printer from falling.

⚠Caution: If the printer needs to be transported without the outer box, be aware of the weight and dimensions of the printer. According to the UL 60950-1 definition the printer is non portable. Use proper transport means to do this safely in order to prevent tripping.

Remove the plastic locking clips from the lower section of the box
Lift the top foam section away from the printer, pulling the print head cable free
Remove the cardboard insert with the materials from the top of the printer
Slide the center seal at the bottom of the glass doors to one side, and then remove all of the remaining seals

What's in the box

Besides the printer itself, a quick start guide, and test print, the Ultimaker S5 is supplied with several hardware accessories. Check if all these items are included before continuing.

Accessories

  • Glass build plate
  • Aluminum build plate
  • Spool holder with material guide
  • Power cable
  • Ethernet cable
  • USB stick
  • Print core AA 0.4
  • Print core BB 0.4
  • XY calibration sheet - glass build plate
  • XY calibration sheet - aluminum build plate
  • Calibration card
  • Nozzle cover (3x)

Consumables

  • Tough PLA (750 g)
  • PVA (750 g)
  • Glue stick
  • Oil
  • Grease

Tools

  • Hex screwdriver 2 mm

✔ Tip: Another print core AA 0.4 is placed in print head slot 1 of the Ultimaker S5.

Ultimaker S5 accessories

Index
Support