Installing the hardware accessories

Connect the Bowden tubes

  1. Remove the clamp clips from the print head and insert the Bowden tubes. The Bowden tubes connect to the corresponding numbers on the print head.
  2. Secure the Bowden tubes with the clamp clips.
  3. Fit the print head cable clips onto Bowden tube 2.

Step 1
Step 2
Step 3
Step 4

Place and connect the NFC spool holder

  1. Insert the spool holder into the back panel and push until it snaps into place.
  2. Secure the cable from the spool holder behind the cable clips in the back panel.
  3. Connect the cable to the NFC socket at the back of the printer.

Insert spool holder
Connect NFC cable

Place the glass build plate

  1. Open the glass doors.
  2. Open the two build plate clamps at the front of the build plate.
  3. Gently slide the glass plate onto the build plate and ensure that it snaps into the build plate clamps at the back.
  4. Close the two build plate clamps at the front to secure the glass build plate and close the glass doors.

✔ Tip: For the first use it is recommended to use the materials supplied with the Ultimaker S5. These should be printed on the glass build plate.

Open the glass doors
Release build plate clamps
Insert glass plate
Secure build plate clamps

Connect the power cable

  1. Connect the power cable to the power socket at the back of the Ultimaker S5.
  2. Plug the other side of the cable into a wall outlet.

Connect the power cable

Index
Support