- Unable to download firmware due to lack of space on printer
- Unable to download firmware due to lack of space on printer
- This printer does not support printing with abrasive materials
- Flow sensor error
- Print job not suitable for printer
- Motion controller failed to update
- Incorrect build plate temperature specified
- Incorrect print temperature specified
- Active leveling correction failed
- Print head sensor error
- Safety circuit error
- I2C communication error
- Print head communication error
- X or Y axis stuck or limit switch broken
- Z axis stuck or limit switch broken
- Print core heater error
- Build plate max temp
- Print core min temp
- Print core max temp
- Unspecified error
- PrintCore taking too long to warm up
- Difference between detected height of both PrintCores exceeds realistic values
- This print job is not suitable for this printer
- The motion controller failed to be updated
- An incorrect build plate temperature is specified
- An incorrect print temperature is specified
- Active leveling correction failed
- There was a sensor error within the print head
- There was an error with the safety circuit
- There is an I2C communication error
- There is a communication error with the print head
- The X or Y axis is stuck or the limit switch is broken
- The Z axis is stuck or the limit switch is broken
- Heater error on PrintCore
- Max temp. error on the build plate sensor
- Min temp. error on PrintCore
- Max temp. error on PrintCore
- An unspecified error has occurred
- Stopped temp sensor
- Stopped temp sensor BED
- Heater Error
- X or Y Switch Broken
- Z Switch Broken or Z Switch Stuck
- Error while reading SD card
- Safety circuit error
- MINTEMP/MAXTEMP Error
- MINTEMP/MAXTEMP Error BED
- Heating Failed
Top 10 solutions
- What does a successful first layer look like?
- How to fix an ugly print?
- How to plug in the power cord correctly?
- How to insert filament?
- How to fix the most common Ultimaker error messages?
- Where can I find official Ultimaker resellers?
- How to solve common Cura issues?
- How to unclog an Ultimaker nozzle?
- How to fix under extrusion?
- How to clean print core BB?