Error messages

Flow sensor error

Flow sensor error

Print job not suitable for printer

Print job not suitable for printer

Motion controller failed to update

Motion controller failed to update

Incorrect build plate temperature specified

Incorrect build plate temperature specified

Incorrect print temperature specified

Incorrect print temperature specified

Active leveling correction failed

Active leveling correction failed

Print head sensor error

Print head sensor error

Safety circuit error

Safety circuit error

I2C communication error

I2C communication error

Print head communication error

Print head communication error

X or Y axis stuck or limit switch broken

X or Y axis stuck or limit switch broken

Z axis stuck or limit switch broken

Z axis stuck or limit switch broken

Print core heater error

Print core heater error

Build plate max temp

Build plate max temp

Print core min temp

Print core min temp

Print core max temp

Print core max temp

Unspecified error

Unspecified error

PrintCore taking too long to warm up

PrintCore taking too long to warm up

Difference between detected height of both PrintCores exceeds realistic values

Height PrintCores exceeds realistic values

This print job is not suitable for this printer

Print job not suitable for printer

The motion controller failed to be updated

Motion controller failed to be updated

An incorrect build plate temperature is specified

Incorrect build plate temperature

An incorrect print temperature is specified

Incorrect print temperature

Active leveling correction failed

Active leveling correction failed

There was a sensor error within the print head

Sensor error print head

There was an error with the safety circuit

Error with the safety circuit

There is an I2C communication error

I2C communication error

There is a communication error with the print head

Communication error print head

The X or Y axis is stuck or the limit switch is broken

X/Y axis stuck or limit switch broken

The Z axis is stuck or the limit switch is broken

Z axis stuck or limit switch broken

Heater error on PrintCore

Heater error PrintCore

Max temp. error on the build plate sensor

Max temp. error build plate sensor

Min temp. error on PrintCore

Min temp. error PrintCore

Max temp. error on PrintCore

Max temp. error PrintCore

An unspecified error has occurred

Unspecified error

Stopped temp sensor

Stopped temp sensor

Stopped temp sensor BED

Stopped temp sensor BED

Heater Error

Heater Error

X or Y Switch Broken

X or Y Switch Broken

Z Switch Broken or Z Switch Stuck

Z Switch Broken or Z Switch Stuck

Error while reading SD card

Error while reading SD card

Safety circuit error

Safety circuit error

MINTEMP/MAXTEMP Error

MINTEMP/MAXTEMP Error

MINTEMP/MAXTEMP Error BED

MINTEMP/MAXTEMP Error BED

Heating Failed

Heating Failed

Support