Tucci Hot Rods: 3D printing final custom car parts
Snow Business: 3D printing final parts for high-value snow machines
Volkswagen Autoeuropa: Maximizing production efficiency with 3D printed tools, jigs, and fixtures
Thanks a lot for all these feedbacks! Always much appreciated. :)To summarize I'll keep in mind that UMO+ can reach similar quality levels than the upper models provided that some adjustments are made. So for the quite inexperienced user I am, UM2+ may be a better choice. So I can rely on...
Elaup replied to topic:
Thank you for these very helpful explanations Tommyph1208! About the multiple nozzles of the UM2+, do you think that the same results could be obtained with an UMO+ just by changing the nozzle?
Thanks a lot for this reply, that's very good to know !I have to say I'm quite surprised to read this. I expected that the fact that it is manually assembled by the user could have an impact on the accuracy, but it seems like it's not the case?I also thought that the UM2+, with i...
Is there a printing quality difference between the printers of UM range?
Elaup posted a
I still struggle to assign one extruder to the shell and the other one to the infill. For two different parts on the plate it is very easy, but for different areas of one same part I can't figure out how to do this. Is it necessay to divide the model before or something like that?
Ok. I think I had a misconception of the situation before your explanations. I assumed that the extruded strings could be considered as round, I mean with a circular section. And so that to have thinner strings on the shell, it was necessay to have more layers locally, like on this scheme. Is my und...
Thanks for your comment Ahoeben! :) This is very good to know!I added an UM3 on Cura and I tried to assign one extruder to the infill and the other one to the shell just to see the impact it has on duration, but I can't figure out how to set this up. I don't find eather the "Infill layer t...
Thanks a lot for sharing this! Do you know if this is possible with every printer of the Ultimaker range, provided that some adaptations are made? Or is it only a feature available on the last model?Thanks again! :)
Is it possible to set up different layer heights for shell and infill?