Volkswagen Autoeuropa: Maximizing production efficiency with 3D printed tools, jigs, and fixtures
Tucci Hot Rods: 3D printing final custom car parts
Snow Business: 3D printing final parts for high-value snow machines
Yes, they have, but they may need smaller or bigger outer wall diameter, they may need different speeds which are related to material type. When selecting Normal Quality and my ABS material i get only temps right. Nothing else. So the problem is, that when You use UM materials, its all wel...
FormFaktor replied to topic:
Cura materials and print settings management
FormFaktor posted a
Thank You Daid for Your reply. I'm going to put 5 fans in total and that is all. Should work I think.Thanks!
As far as I print wide objects that sticks well and are stiff its ok, but with little pilars with 1mm radius and no infill after 4-5cm of printing it gets bad. Printer drops material on a shaking piece of plastick and leaves bubbles rather than proper print. :/
Hi guys,I'd like to refresh this topic. I think Im having same problem. I made tests and it turns out that printbed vibrates after few centimeters of fast printing. If i take glass plate and heatbed leaving only aluminium plate, it is quite stiff. But if I reattach everything, no matter ho...
UM3 power source for modification
1. Well, as I've read and tested in printers using bowden to guide filament from extruder to printcore 4mm of retraction is a point when retraction starts to happen. This happens due to a tension in bowden tube, and retraction of 4mm just lower the tension. In UM machines retraction should...
I admit that travel speed is set to 250, but everything works fine with one-nozzle printig even with more than one element. This also happens to UM PVA material when printing with both nozzles. Its wierd because everything was fine until I updated cura and UM3 to beta softwares. Switching back didn'...
So as an update I have to tell, that problem is not solved. Even with Prime Towers enabled printer attaches strings of material to printed object right after nozzle switch. I reduced temperature to prevent material from leaking but it didn't work.