Volkswagen Autoeuropa: Maximizing production efficiency with 3D printed tools, jigs, and fixtures
Tucci Hot Rods: 3D printing final custom car parts
Snow Business: 3D printing final parts for high-value snow machines
Acceleration and Jerk settings in Cura
InspGadgt posted a
I've made several changes since the original post...upped the heat to 220 degrees, slowed down the print to 40mm/s, took out the z-hop I had, and lowered the layer height to .15. These all helped but the problem isn't gone. There are less thin sections but still several holes. When I watched the...
InspGadgt replied to topic:
In layer view only the 1st layer shows internal structure...which is probably why it prints that way too. I haven't been able to figure out how to get the interior structures to show in layer view.
Huh? What's a G92 Z?I did a 1 wall heat test and flow test and came out with 210 degrees and 105-110% flow for best layer adhesion.Pretty close to the same settings I have been settling on with Cura 15.4. Except for the travel speed. &nbs...
Need help with thin wall printing in Cura
InspGadgt's album called Uploads