9
V
VitR Level 1 - Starter Points: 9
Posts: 5

Location: Czech Republic Printers: Ultimaker 3
Posted by
V
VitR

Posted Jun 14, 2017 - 11:35 AM • Edited  Jun 21, 2017 - 3:20 AM
Used in: Architecture
3D printer: Ultimaker 3
Material: PLA
Color: White
Nozzle diameter: 0.40 mm
Layer resolution: 201-250 micron
Print time: > 48 hours

Hi ultimakers,

Here is one of my projects which is made on Ultimaker3.

Reply to print
Share
Embed
Copy
Copy
3 replies
 249 9
Sort 
gr5 Moderator Points: 16379
Posts: 9810
Location: Boston, United States Printers: Ultimaker 2, Ultimaker Original, Ultimaker 2 Extended, Ultimaker 2 Go, Ultimaker 3
Posted by
gr5

Posted Jun 14, 2017 - 1:58 PM

Nice.

Did you print the black trim items in place with the second nozzle? Or did you insert those later?

V
VitR Level 1 - Starter Points: 9
Posts: 5
Location: Czech Republic Printers: Ultimaker 3
Posted by
V
VitR

Posted Jun 14, 2017 - 2:16 PM

Hi,

windows frames and doors was printed with the second (gray pla) printcore. Removing supports was little bit complicated but possible (triangle support with support interface). On second floor I use same principle but support from basic (white), zigzag with interface and 0.2mm z distance.

SandervG Team Ultimaker Points: 7876
Posts: 4411
Location: Geldermalsen, Netherlands Printers: Ultimaker Original+, Ultimaker 2+
Posted by
SandervG

Posted Jun 14, 2017 - 3:30 PM

Looks very clean! Almost like a render. Nice job!

3 replies
 249 9
Sort 
Support